Computer Aided Drafting


This 20 hour course is designed to develop an Introductory knowledge of Computer Aided Drafting. The student will learn basic drafting concepts and techniques using AutoCAD 2D Mechanical Drafting Software.  

Class will be held on Tuesdays & Thursdays 6-9PM


Upon completion of this course the student should be proficient in;

         Understanding the fundamentals of basic computer aided drafting       software.

         Setting up the drafting environment.

         Tool bar selection and management

         Drawing file management

         Template creation and management

         Creation of 2D wire frame drawings


1. Introduction to AutoCad Mechanical

         Drafting environment set up

         Toolbar usage and selection

         View navigation

         Drawing template development and importation

         Drawing storage and management

2.   2D Orthographic drafting techniques

         Geometry and feature creation

         Layer creation and management

         manipulation of elements and features.

         3rd Angle projection display and views

         Tolerance techniques and implementation

         Drafting examples and workshops



Register Below or
Contact the MA Training Department at 717-843-3891

Registration Policy: 
Fee must accompany non-member registration.  Cancellation policies apply.  Cancellations with less than 10 days notice will be charged.  No shows will be charged.

Date: TBD
Sessions: 10
Times: Tuesdays & Thursdays 6-9 pm
Location: MTC, 320 Busser Rd
Cost (member): 600
Cost (non-member): 1000

"Thank you ... for participating in our Manufacturer's Summit" Adams County Economic Development Corporation
The Manufacturers' Association
320 Busser Road, 2nd Floor
P.O. Box 493
Emigsville PA, 17318
(717) 843-3891